You here: Crop science / Frame area

Rose (protected ground)

Application technology:

1. Pre-treatment of grafts and seedlings. Lignohumate solution concentration – 0.05% (5.0 g of Lignohumate A, AM, or 0.025 l of Lignohumate B, BM per 10 l of water). Planting stock treatment (soaking for up to 10-20 hours) by a Lignohumate solution with a consumption rate of 1 l per 50 grafts or 5 seedlings.

2. Foliar dressing at the early ratooning phase. Lignohumate solution concentration – 0.05% or 50 g of Lignohumate A, AM, or 0.25 l of Lignohumate B, BM per 100 l of water. Standard or low-capacity sprayers can be used.

3. Foliar dressing at the early budding phase. Lignohumate solution concentration – 0.05% or 50 g of Lignohumate A, AM, or 0.25 l of Lignohumate B, BM per 100 l of water. Standard or low-capacity sprayers can be used.

4. Foliar dressing at the after-cut phase. Lignohumate solution concentration – 0.05% or 50 g of Lignohumate A, AM, or 0.25 l of Lignohumate B, BM per 100 l of water. Standard or low-capacity sprayers can be used. It is recommended to apply Lignohumate in a mixture with protectors and soluble fertilizers.

5. If an irrigation system is used, then the preparation is to be applied with water several times per season. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution. If drip irrigation is used, then the preparation is to be applied at the last or last-but-one watering 1 time each 7-10 days. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution.

Thus, thanks to the above described properties we have:

- increased crop yield (more flower stalks and less blind flower stalks);

- better crop quality (more intensive colouring of leaves and flowers, higher density of buds and stalks).

By virtue of its physiological requirements it is most preferable to apply to Rose a potassium form with addition of a set of microelements.