You here: Crop science / Open ground

Cotton plant

Application technology:

1. Seed pre-treatment*. Application rate of the preparation – 100-150 g of Lignohumate A, AM, or 0.5 – 0.75 l of Lignohumate B, BM per 1 ton of seeds. Spraying/soaking of seeds before sowing for a period of 12 to 18 hours at the consumption rate of 500 - 700 l per 1 ton of seeds. Combination with protectants or bio-preparations is recommended.

2. Foliar dressing during vegetation phase. Application rate of the preparation – 150 g of Lignohumate A, AM, or 0.75 l of Lignohumate B, BM per 1 hectare. Consumption rate of the solution – 200 - 300 l per one hectare. Standard or low-capacity sprayers can be used. It is recommended to apply Lignohumate in a mixture with protectors and soluble fertilizers.

3. If an irrigation system is used, then the preparation is to be applied with water several times per season. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution. If drip irrigation is used, then the preparation is to be applied at the last or last-but-one watering 1 time each 7-10 days. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution.

Thus, thanks to the above described properties we have:

- increased drought tolerance;

- crop yield is increased.

By virtue of its physiological requirements it is most preferable to apply to Cotton plant a potassium form with addition of a set of microelements.

*- only if seeds are not incrusted or pelletized.