You here: Landscaping / Floriculture

Tulip

Application technology:

1. Pre-treatment of bulbs. Application rate of the preparation – 50 g of Lignohumate A, AM, or 0.25 l of Lignohumate B, BM per 10 l or water. Planting stock treatment (soaking for up to 10-12 hours) by a Lignohumate solution with a consumption rate of 1 l per 10-40 bulbs. Combination with protectants or bio-preparations is recommended.

2. Foliar dressing after flower stalks are cut. Application rate of the preparation – 150 g of Lignohumate A, AM, or 0.75 l of Lignohumate B, BM per 1 hectare. Consumption rate of the solution – 200 - 300 l per one hectare. Standard or low-capacity sprayers can be used. It is recommended to apply Lignohumate in a mixture with protectors and soluble fertilizers.

3. If an irrigation system is used, then the preparation is to be applied with water several times per season. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution. If drip irrigation is used, then the preparation is to be applied at the last or last-but-one watering 1 time each 7-10 days. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution.

Thus, thanks to the above described properties we have:

- increased crop yield;

- better crop quality (deeper colouring of leaves and flowers, better density of buds, better evenness of crop).

By virtue of their physiological requirements it is most preferable to apply to Tulips a potassium form with addition of a set of microelements.