You here: Landscaping / Floriculture

Marigold

Application technology:

1. Seed pre-treatment. Application rate of the preparation – 50 grams of Lignohumate A, AM, or 0.25 l of Lignohumate B, BM per 1 kilo of seeds. Seed treatment (soaking for up to 10-12 hours) by a Lignohumate solution with consumption rate of 3 l per 1 kilo of seeds. Combination with protectants or bio-preparations is recommended.

2. Watering of seedlings. The preparation is applied at the seedling phase while still in the sprouter or at the moment of planting the seedlings into the open ground: to be added into clean water or into fertilizer solutions. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution.

3. Foliar dressing at the budding phase and early bloom. Lignohumate solution concentration – 0.02% or 20 g of Lignohumate A, AM, or 0.1 l of Lignohumate B, BM per 100 l of water. Standard or low-capacity sprayers can be used. It is recommended to apply Lignohumate in a mixture with protectors and soluble fertilizers.

4. If an irrigation system is used, then the preparation is to be applied with water several times per season. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution. If drip irrigation is used, then the preparation is to be applied at the last or last-but-one watering 1 time each 7-10 days. Lignohumate solution concentration – 0.01% or 10 g of Lignohumate A, AM, or 0.05 l of Lignohumate B, BM per 100 l of watering solution.

Thus, thanks to the above described properties we have:

- better crop quality (more intensive colouring of leaves and flowers, better density of buds and stalks; better evenness of the resulting crop).

By virtue of its physiological requirements it is most preferable to apply to Marigold a potassium form with inclusion of a set of microelements.